Storage

About two weeks after the release of DataCore SANsymphony-V 9.0 PSP4 Update 2, DataCore announces Update 3. This is a really short release cycle… DataCore fixed three issues in Update 3. This is an excerpt from the release notes:

Problem: SANsymphony 9.0 PSP4 Update2 failed to update configurations with shared pools on DataCore Servers running SANsymphony 9.0 PSP3, PSP3 U1 or PSP3 U2. Cause: An upgrade script run during installation expected a cmdlet parameter that wasn‟t supported in these versions. Resolution: Updated the script to no longer rely on this parameter.

Note

This article is a bit Brocade-minded, especially with regard to the terminology.

Redundant paths in a network are always a curse. Always? Not always. It depends on the protocol and the kind of network. In a Ethernet network you have Spanning Tree which eliminates redundant paths and builds a loop free network. What about redundant paths in a storage network? When iSCSI and NFS is used, then usually TCP/IP is used on top of Ethernet. Fibre Channel manages redundant paths a bit different. There’s nothing like Spanning Tree. Redundant paths are nothing fancy. They are just there and they are used.

Information

Beginning with the TS251R004 firmware release, the HP MSA VAAI plug-in is no longer supported as the HP MSA controller firmware now uses T10 compliance in an ESX Environment documented in TS251R004.

The HP P2000 G3 and the HP MSA 2040 are two widely used entry-level storage arrays. The P2000 G3 is VAAI capable since firmware version T230. But, contrary to the HP MSA 2040, you have to install the software plug-in for VMware VAAI if you use the P2000 G3. According to the “HP MSA 2040 Storage Configuration and Best Practices for VMware vSphere” whitepaper the MSA 2040 supports VAAI nativly without an additional plugin.

Yesterday I got an e-mail from DataCore in which Update 2 for DataCore SANsymphony-V PSP4 was announced. DataCore found a critical issue in all releases since SANsymphony-V 9.0 PSP3. According to the releases notes a situation can occur, in which storage space reclamation and migration can happen at the same time. This can lead to a situation in which two storage allocation unit (SAU) can point to the same disk offset. If this happens, the disk pool can be marked offline.

In November 2013 I published a PowerShell script on blazilla.de that creates a backup of your SANsymphony-V config by using the DataCore SANsymphony-V PowerShell cmdlets. I would like to thank Marcel, Michael and Frank for their feedback and comments to improve the script. The password is stored in the securestring.txt that needs to be stored in the same directory as the script. Kudos to Marcel, who has the part of the script contributed, that stores the password in an encrypted file.